Whirlpool French Door Refrigerator Brand New Water Wont Dispense

How to fix it.

Whirlpool french door refrigerator brand new water wont dispense.

Do not use an extension cord. Make sure there is power to the outlet. Test the terminals of that solenoid with a multi meter to determine if it has continuity. If the door switch does not have continuity when activated replace it.

If it fails you ll find your whirlpool french door refrigerator ice maker not dispensing ice. Everything works well except for the water dispenser. Reset a tripped circuit breaker. Plug the power cord into a grounded 3 prong outlet.

A single part failure is more likely to happen. Less than 1 year. Replace any blown fuses. If the door switch fails the dispenser will not turn on.

Before determining a control board failure check each ice dispenser component with a multimeter. Took delivery of the brand new fridge whirlpool french door wrf993fifm about 3 weeks ago. 2 you may have bought a cheap aftermarket water filter. To determine if the door switch is defective use a multimeter to test it for continuity.

If the refrigerator water dispenser is not working the door switch might be defective. If the door switch fails the dispenser will not turn on. The water inlet valve opens to supply water to the dispenser. Most refrigerator manufacturers state in the users manual to use.

After removing the switch set your multi meter to the rx1 setting to test your switch for continuity. After delivery on day 1 later in the day after the fridge was left alone for about an hour or so the water dispenser hesitates before water was flowing on the initial demand of water. The valve requires at least 20psi to function properly. To check on the water inlet valve unplug the refrigerator and shut off the water supply to it.

When the freezer door is opened the freezer door switch does two things it turns on the light in the freezer and turns off the ice and water dispenser. Try changing the water filter. If the water inlet valve is defective or if the water pressure is too low the water valve will not open. Remove the back panel and trace the water tube from the water dispenser to the valve to discover the solenoid inlet valve responsible for switching on the water flow.

The symptom is as follows. Make sure that the water pressure to the valve is at least 20 psi. The dispenser control board manages most of the ice dispenser systems. The door switch turns off the ice and water dispenser when the refrigerator door is open.

It will be found behind the pad or lever that is pressed to dispense water. Plug in a lamp to see if the outlet is working. Remove the control panel of your refrigerator to locate the switch. Disconnect the refrigerator from the power source and turn off the water supply before beginning.