Washer Locking Unlocking Door Wont Start

Run a drain and spin cycle.

Washer locking unlocking door wont start.

The switches should have continuity according to their design. Hold down the control lock button on your whirlpool washer for three seconds at the end of the washing. The door lock secures the washer door shut during operation. Reconnect power to washer plug in.

If the washer lid or door won t lock the lock and switch assembly might be defective. It s not normal for it to do it like your saying and then shut off. The lock and switch assembly can fail either mechanically or electrically. Wait approximately 2 minutes for control to reset.

Inspect the door lock for damage. The problem could be with the door interlock. At the conclusion of the cycle the control will activate the door unlock solenoid or will deactivate the door lock wax motor. This could either be the wiring that runs to the door interlock or the door catch not activating the interlock itself.

Door lock motor and switch assembly. If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power. Once the washer door is closed the washer can begin operating. Test any electrical switches with an ohm meter for continuity.

Door lock motor and switch assembly. If not call for service. The most common issue on these is the door lock assembly. The door will not unlock until.

If you decide to tinker with your washer without first unplugging it you could be putting yourself at risk of. The door lock can fail either mechanically or electrically. Wait at least three minutes after the end of the cycle before attempting to unlock your whirlpool washer. If any of these components fails when the door is open the door won t lock.

Door interlock in a front load washer. When this is happening the washer is going a safety check. Replace the entire assembly if any component fails. The door should unlock after this is complete.

The door lock assembly is likely not making good enough contact on the inside so it keeps try to lock and unlock. This is a very common problem. If the door lock is defective the washer door will not latch properly. If the washer door won t open and you hear a clicking sound at the door this could mean that the solenoid is not fully opening to let it unlock or possibly there is a mechanical issue with the latch or the washer door is bent downward in such a way that it still hangs onto the latch and won t let it unlock because of the pressure on the latch.

The door lock assembly on a front load washer includes a safety switch that detects whether the washer door is closed a latch and a locking mechanism. If the lights come on but the machine won t start this will probably be the cause. Once you ve unplugged your washer lay the power cord flat against the side of the cabinet and tape it down to keep it. If a component fails with the door is closed the door won t open.